Aerial map
You can move around with your keyboard
plus
minus
left
right
Drop pin on the map to start a new report
space
Press space again to adjust the location
space
Start new report here Reposition report here
Back to all reports

Edge of the metalled surface breaking up

Reported via desktop in the Roads/highways category by David Turner at 11:57, Tue 3 August 2021

Sent to Shropshire Council less than a minute later. FixMyStreet ref: 2910900.

At the bottom of the lane "MANOR FARM JUNCTION TO SHREWSBURY AND ATCHAM DISTRICT BOUNDARY TICK WOOD, WYKE, MUCH WENLOCK, SHROPSHIRE, TF13 6NZ" the tarmac is breaking up. If a small car drops into trench that has been created by vehicles and running water, in order to give way another vehicle heading in the opposite direction, there is a probability that there will be damage.

RSS feed of updates to this problem Receive email when updates are left on this problem.

Updates

  • The area has been marked up with paint

    Posted by David Turner at 12:45, Tue 31 August 2021
    Still open, via questionnaire

  • The paint is now fading

    Posted by David Turner at 13:09, Tue 28 September 2021
    Still open, via questionnaire

  • Photo of this report zoom

    The upper and lower lengths of this problem have had tarmac poured onto them, but the middle seems to have been missed out for reasons I can’t fathom,

    Posted anonymously at 19:36, Thu 14 October 2021

  • Photo of this report zoom

    Only partial remediation has taken place - a stretch in the middle has been missed out

    Posted by David Turner at 18:05, Tue 26 October 2021
    Still open, via questionnaire

  • We understand this issue has been resolved so this enquiry will now be closed.

    The road will continue to be regularly inspected. Any defects found to be above the action threshold will be prioritised for repair as per our policy.

    State changed to: Closed

    Posted by Shropshire Council at 18:14, Mon 11 November 2024

Only the original reporter may leave updates. If you made the original report please log in to leave an update.